Our Solutions

For a fraction of the cost of UPVC replacement windows we can thoroughly service and draught-proof your windows as described below and providing these benefits:

  • Noise penetration is reduced by approximately 50%.
  • Heat loss through the windows is reduced by up to 70%.
  • Dust, draughts and rattles are totally eliminated, whatever the weather.
  • Windows will open and close smoothly and securely.
  • Windows can be easily removed from the inside in order to decorate.
  • Windows are left with new cords and beading. All loose putty is removed and replaced with new.

Rot found in cills, boxes and sashes will be repaired if possible but, if not, hardwood replacements can be fitted with the original profiles being accurately matched.


The draught-proofing system

Note 1) - All Weatherstripping is selected to suit varying widths of gaps. It meets all requirements of BS 7386 Specification for Draughtstrips for draught control of existing doors and windows in housing. It is also silicone treated to repel water and is ultra violet stabilised.

Note 2) - The windows will be left easily removable from the new, high quality sash cords.


A draught-proofing system such as ours is generally accepted and often suggested by Conservation Officers. See page 9 of:

http://www.cheltenham.gov.uk/downloads/ The_Conservation_and_Renewal_of_Timber_Windows_1_.pdf

However, if you live in a listed building or in a conservation area please contact your Conservation Officer for specific advice.

Cheltenham Borough Council Planning Dept (01242 264328) or Stroud District Council (01453 766321).

Our system is also recognised by HMRC as being a 'significant energy saving measure'. This enables us to charge VAT at the reduced rate of 5%.



Mid & Bottom Rail (2 and 4)

  • Grooves routed to sash mid rail and bottom rail.
  • Pile carriers installed.
  • Draught-proofing pile (weatherstripping) is selected to suit varying widths of gaps.

A New Two-piece Parting Bead (1)

  • U shaped section screwed into original parting bead groove.
  • Detachable pile carrier snapped into U section to allow removal of sashes.
  • Height of draught-proofing pile selected to eliminate air infiltration and allow low friction sliding.

Staff Bead (3 and 5)

  • Existing staff bead replaced by new staff bead incorporating the draught-proofing pile.
  • Painted with acrylic white primer conforming to BS 5082.
  • Fitted with brass screws for easy release.